Ed Donaldson Hardware Restorations Misc Hardware Page 3

Reference # 710-304

2 available

Note: Sale of this item is not complete until you receive confirmation from us.

Two matching wrought iron building ties, circa 1800. Mounted through the floor joists of the second or the attic floors in primarily brick buildings/houses to keep the brick from bulging out. The round rosettes show on the exterior of the building and measure 8 3/4" diameter x 3/8" thick. The rod is 20" long with the square stop 1 1/2" square. Each tie rod has a substantial wing nut on the threaded end for adjustment. Original finish - not recently restored.

Reference # 998-715

2 available

Note: Sale of this item is not complete until you receive confirmation from us.

Early 20th century toilet roll holders with white porcelain ends and wooden rollers. The porcelain ends measure 2 1/2" high x 2 1/4" wide with a mounted extension of 3 1/4". Porcelain is in excellent condition with no cracks. We have adapted Plexiglas wall mounts to install these pieces as shown in photo below right. These pieces were originally of sheet metal. The mounts are screwed into the wall and the ends slide down over them to keep the holder in place.

Early 1900 White Porcelain Toilet Roll Holders w/Wood Rollers
Price $ 50.00 each

Reference # 998-429

1 pair available

Note: Sale of this item is not complete until you receive confirmation from us.

Pair of ornate Victorian shelf brackets, circa 1885, in cast iron. Brackets measure 8 3/4" x 6 7/8". Restored and complete with mounting screws.

Reference # 998-291

1 pair available

Note: Sale of this item is not complete until you receive confirmation from us.

Victorian shelf brackets in cast iron, measuring 6" x 8". These shelf brackets may be used horizontally or vertically. In original black finish with new slotted mounting screws.

Reference # 998-678

1 pair available

Note: Sale of this item is not complete until you receive confirmation from us

Victorian decorative stair rail brackets in cast iron, circa 1885. These brackets support a stairway railing and are mounted from the wall. Measuring 3 1/2" high overall with an extension of 3 3/4" from the wall. The back mount is 3" high x 1 3/8" wide. Accompanied by 2 plain cast iron rounded braces (seen to the right of the brackets). These rounded braces mount under and into the cutout on the extension of the bracket and the railing screws into them to mount - the braces swivel on the bracket and can be adjusted for the pitch of the railing. Two complete brackets and braces make up this matching set for a shorter stair rail. Restored and complete with mounting screws.

Reference # 710-265

2 available
Note: Sale of this item is not complete until you receive confirmation from us.

Heavy well cast vintage Equestrian related wall racks, original red paint, measuring 11" high overall x 10" wide x 11 1/2" extension from the wall. The mount back measures 9 1/2" high x 8 1/2" wide. Excellent condition.

Reference # 998-718

5 sets available

Note: Sale of this item is not complete until you receive confirmation from us.

Depression Era clear glass furniture coasters, used with heavier pieces of furniture to protect the wooden floors from scratching and scuffing. Measuring 2 1/2" diameter across base - 3/4" high at sides - with a 1 3/4" diameter opening across the top. No cracks or chips - in very good condition.

Reference # 998-717

1 pair available

Note: Sale of this item is not complete until you receive confirmation from us.

Antique picture hangers in cast iron parrots with threaded screw mounts, manufactured circa 1910. Both hangers are in their original paint with 80% of it still intact. This type of picture hanger was screwed into the wall and the pictures were hung from wires, etc, that were looped over the parrots. Parrots measure 2 1/4" high x 3/4" at widest with a 7/8" screw. Each parrot is shown below in close-ups.