Ed Donaldson Hardware Restorations Window Hardware page 8

Reference # 640-631

Note: Sale of this item is not complete until you receive confirmation from us.

Victorian window or sash lifts in decorative cast iron, manufactured circa 1885. Lift measures 1 1/2" wide x 1 3/8" high overall - the flat back measures 1" high. Restored and ready to install with screws.

Reference # 640-881

Note: Sale of this item is not complete until you receive confirmation from us.

One of the earliest Victorian window or sash lifts in decorative cast brass, manufactured circa 1865, by the Sargent & Co. Lift measures 1 1/2" wide x 1 1/4" high overall - the flat back measures 3/4" high. The top of the finger curl is decorated as well. At some earlier time, tiny holes were drilled in each of the curved tops of the lifts as shown in photo below. This does not interfere with the function and does not show when mounted. Restored and ready to install with screws.

Reference # 640-758

1 available

Note: Sale of this item is not complete until you receive confirmation from us

A typical early forged iron exterior shutter bolt, circa 1860. What is not typical is that this bolt is still in the original state after manufacturing and has never been used. Bolts were made in one piece with the keeper attached. The bolts were sold this way and when the home owner used it, they detached the keeper from the bolt. There is a line incised into the metal (can be seen in the photos) where the keeper is to be detached. This bolt and keeper were never detached and are still in the original single piece. Bolt measures 6 3/4" x 1 3/4" - keeper measures 1 3/4" x 3 1/8". Overall length is 9 7/8".

Forged Iron Exterior Shutter Bolt, Original Condition
Price $ 35.00

Reference # 998-512

11 pair available

(1 pair is as pictured)

Note: Sale of this item is not complete until you receive confirmation from us

Eleven pair of double blind brackets in cast iron from the late 19th Century. Brackets are 4" high and extend 1 1/2". Made to accommodate two sets of roller blinds - one for the top window and one for the bottom window. Used often in commercial settings such as a factory or school.

Set of 11 pair of Double Blind Brackets
Price $ 45.00

Reference # 640-836

1 available
Note: Sale of this item is not complete until you receive confirmation from us.

Cast iron side sash lock with a decorative linear pattern, circa 1885, in original finish - remnants of bronze plating visible. Measuring approximately 2 1/2" overall x 1". Face plate is 1 1/2" high x 3/8" wide. Mount is 1 3/4" high x 15/16" wide. These locks were mounted on the window sash - the arm moves up and down and pushes the pressure plate on the left in and out. This pressure plate will hold the window closed or open in any position with pressure on the window sill. Locked position pictured with plate extended. Complete with slotted wood screws.